Nitro RC pull start, comes complete with screws and one way bearing.
12mm Hex one way bearing fitting (M12 Socket Size - Measure Across The Flats).
32mm Length (Across Backplate)
32mm High (Across Backplate)
27mm between fixing hole centres. Measured both vertically and horizontally
19mm Depth / Width
6mm diameter starter shaft
The screws supplied will suit many engines. they may need to be cut to size.
From my experience this pull start will fit the following engines. it may also fit others.
VX Engines - .12, .15 and .18
Acme and Infinity engines
Thunder Tiger GP15 and 21Pro
XTM .18 Engine
Tamiya Engine with a Blue cylinder head (not the older silver head versions)
Traxxas TRX 2.5
Ansmann .15 and .21
* This pull start is only really suitable for 1/10 scale cars and engines with normal compression. If you have a 1/8th vehicle or a high compression engine you will need an upgraded version of this pull starter.
The upgraded version of this pull start which has been rewound with "unsnappable" Kevlar cord is also available on this site.