A set of two high quality, high speed bearings for use on a Nitro Engine, to allow the clutch or bell housing to rotate smoothly. Works with single speed and dual speed systems.
Most engines will require a pair of these fitted in the front and rear of the clutch or bell housing.
Bearing size is 10mm wide x 4mm deep with a 5mm central hole for the crankshaft.
It is compatible with most engines from the following manufacturers. If in doubt, please send me a picture of your bell housing, and I will confirm.
Traxxas, HPI, Protech, Thunder Tiger, HSP, VX, Himoto, Kyosho, Flying Point, Haiboxing, Acme, Turnigy, CEN, Losi, Smartech, XTM, Team Associated, Redcat, Duratrax, Silverline, Tamiya, FTX, and many more...... If unsure - please ask!