Main Banner + Brands.jpg

New Models, Spare Parts and Award Winning Service!

 
Semi-LARGE RCS Logo White-01.png

New Models, Spare Parts and Award Winning Service!

Asset 2.png
Asset 1.png
 

Thunder Tiger Pro Pull start PN0073 for TS4N and SSK

284216219235

£18.99

PayPal Heading

Looking to pay with Klarna? You can do this at Checkout!

 

Qty
 
This pull start will only fit the following engines. 
Thunder Tiger Pro12 engine
Thunder Tiger Pro15 engine

OK, so before you buy, please understand that this is an aftermarket version of the Thunder Tiger original pull start as the originals are no longer available. The casing is a little less flexible than the original, but the spool has been fitted with Kevlar cord, so will not easily break and should last longer than the original. These have been designed and manufactured by RCScrpayard as there is no other alternative pull starts available that will fit the Pro12 and Pro15 engines.

It has been designed and 3D printed by RCScrapyard using ABS Plastic which is heat tolerant, hard wearing and durable. It is a new product for us, and only a limited amount are being produced until customer feedback is recieved. If you purchase please would you let me have your feedback once fitted, in order to help improve the design further.
Measurements
9mm Hex aperture for Thunder Tiger starter shaft (Measured across the flats).

37mm Length (across backplate)

37mm High (across backplate)

30mm between fixing hole centres. Measured both vertically and horizontally

19mm Depth / Width 

The screws supplied may need to be cut to size.

To be sure - take a look at the last photo in the listing. If the back of your engine looks like this - then it will fit. If in doubt - please ask me.
.