63bbc9ff05a15174cdda1662472bf392 (1).png
 
 
RCS-Racing-Performance-BLACK-eng.png
 
63bbc9ff05a15174cdda1662472bf392 (2).png
RCS-Racing-Performance-BLACK-eng.png
 
 
 

RC Foam Air Filter replacement set for 1/8 filters with Filter Oil

285401783908

£11.99

PayPal Heading

Qty
This is a full foam set which will fit most 1/8th size air filters. This is a higher quality than supplied as standard with most filters.
It consists of a two piece set with a coarse foam outer layer to catch larger particles, and a fine foam inner for superior filtration of small particles, leaving your engine free to breathe easily.
The inner foam is finer than standard filtration foam, providing additional protection to your engine.
Dimensions: - Note - being foam, both will stretch or squash a few mm to fit.
Inner Foam (Fine Filter)
Length = 38mm
Inner Diameter =12mm
Outer Diamter = 32mm
Outer Foam (Coarse Filter
Length = 38mm
Inner Diameter = 39mm
Outer Diameter = 45mm

RCS Racing Air Filter Oil has been developed over many years of running Nitro Engines, and has been specially formulated to provide maximum dust protection for your engine while allowing it to breath normally, assuring full power without restriction. 

Many big brand Air filter oils are to thick and sticky in consistency which has the effect of choking the engine if too much is used. This oil has been designed with just the right viscosity to allow engines to breath properly, even if a little too much is used. 

When fitting a new air filter, or if you have washed your existing filter out with fuel, you will need to add some air filter oil to it to stop the fine particles of dust and grit damaging the engine. 

The bottle of oil is supplied in a resealable plastic bag. Use the bag to place your filter foam together with a few drops of oil. Close the bag, expelling any excess air, and then massage the oil into the foam.

Please see my other listings for  1/8th and 1/10 scale complete filters in Metal and Rubber
.